Collector & Muffler, for Bobcat Style Header 1-1/2 U-Bend

EMPI Collector & Muffler for Bobcat Style Header (1-1/2" U-Bend)

Product Overview

The EMPI 00-3465-0 is a specialized exhaust solution designed to replace the standard collector on typical Bobcat-style headers. This kit converts your existing open exhaust into a dual-chambered U-bend muffler system, significantly reducing noise levels while maintaining the classic off-road look. Constructed from raw steel, this kit includes both the collector and the muffler components specifically sized for 1-1/2 inch exhaust systems.

Vehicle Fitment and Compatibility

This collector and muffler assembly is engineered for air-cooled Volkswagen applications utilizing a Bobcat-style header. It is a popular choice for VW Beetles, Dune Buggies, Sand Rails, and Manx-style shells where a 1-1/2 inch primary tube diameter is used. Please verify your header tube diameter before ordering to ensure a proper slip-fit connection.

Pro Tech Tips from Appletree Auto

Strip the Storage Paint: The black coating on this muffler is intended for rust prevention during shipping and storage only. It will burn off almost immediately once the engine reaches operating temperature. For a long-lasting finish, we recommend stripping the storage paint and applying a high-quality, high-temperature ceramic or header paint before installation.

Check Your Clearances: Because this unit converts a standard collector into a U-bend configuration, the muffler will sit in a different position than a standard stinger. Always mock up the fitment to ensure adequate clearance between the muffler body and your vehicle's rear apron, bumper, or cage work to prevent heat damage or rattling.

Ensure a Gas-Tight Seal: To prevent exhaust leaks at the slip-joint where the collector meets the header, use a high-temperature exhaust sealant or heavy-duty muffler clamps. A tight seal at this junction is critical for maintaining proper backpressure and preventing "popping" during deceleration.