Push Rod Tube Seals, for Center Of Spring Loaded Tubes

EMPI Push Rod Tube Seals for Center of Spring Loaded Tubes

VW Fitment and Compatibility

These EMPI replacement seals are designed specifically for the center section of adjustable, spring-loaded, or threaded pushrod tubes. They are essential for maintaining a leak-free seal in the telescoping portion of the tube assembly. This set of 8 rubber seals is a direct replacement for the seals found in EMPI 4011 and 4012 pushrod tube kits, which are commonly used on VW Type 1 Beetle, Type 2 Bus, and Type 3 air-cooled engines.

Pro Tech Tips for Installation

Lubricate Before Assembly: Always apply a light coating of clean engine oil or assembly lube to the seals before sliding the inner and outer tube sections together. This reduces friction and prevents the rubber from binding, bunching, or tearing during the assembly process.

Inspect for Sharp Edges: Before installing the new seals, check the ends of your adjustable pushrod tubes for any sharp burrs or metal nicks. Use a piece of fine-grit sandpaper to smooth these edges, as even a small burr can slice the new rubber and cause an immediate oil leak.

Verify Square Seating: Ensure the seal is seated perfectly square within the internal groove of the tube. If the seal is twisted or pushed in at an angle, it will not provide a uniform 360-degree seal against the telescoping inner tube, leading to persistent leaks once the engine reaches operating temperature.