Differential Carrier Bearing For Type 2 Bus 68-75

IAP Differential Carrier Bearing for VW Type 2 Bus (1968-1975)

Vehicle Fitment and Compatibility

This IAP differential carrier bearing (Part #002-517-185) is a precision replacement component designed specifically for the Volkswagen Type 2 Bus. It is compatible with Bus transaxles produced from 1968 through 1975. Maintaining high-quality carrier bearings is vital for ensuring proper differential alignment and preventing excessive noise or gear wear within your VW aircooled transmission.

Pro Tech Tips for Installation

Tip 1: Use a Hydraulic Press. To avoid damaging the bearing races or the rollers, always use a hydraulic press to install the bearing onto the carrier. Never use a hammer and punch, as uneven impact can cause micro-fractures or flat spots on the precision surfaces, leading to premature failure.

Tip 2: Inspect the Carrier Journal. Before pressing the new bearing on, carefully inspect the carrier journal for any signs of wear or "spinning." If the old bearing spun on the carrier, the surface may be undersized. The bearing must be a tight press-fit; if it slides on by hand, the carrier may need to be replaced or repaired to prevent the new bearing from spinning.

Tip 3: Pre-Lubricate for Initial Start-up. Although the transmission will eventually submerge the bearing in gear oil, you should apply a liberal coating of high-quality 80W-90 or 75W-90 gear oil to the rollers and races during assembly. This ensures the bearing has immediate lubrication during the critical first few rotations of the transaxle after a rebuild.