Intake Boot Clamp, for Dual Port Boots, Small Side, Pair

EMPI Intake Boot Clamps for Dual Port Boots - Small Side (Pair)

Product Overview

Maintain a leak-free intake system with these EMPI intake boot clamps, specifically designed for the small side of VW dual port intake boots. These high-quality replacement clamps ensure your intake boots stay firmly seated, preventing the vacuum leaks that commonly cause poor idling and engine hesitation in aircooled Volkswagens. This set includes two clamps (one pair), providing the necessary hardware for both sides of your dual port manifold setup.

Vehicle Fitment

These clamps are compatible with all aircooled VW Type 1, 2, and 3 engines featuring dual port intake manifolds. This includes the Volkswagen Beetle, Super Beetle, Karmann Ghia, VW Bus, and Type 3 Squareback or Fastback. They are also the standard choice for dune buggies, sand rails, and trikes utilizing a dual port 1600cc based engine.

Pro Tech Tips

Tip 1: Complete Your Installation. It is important to remember that dual port intake boots require two different sizes of clamps for a proper seal. These are the "small side" clamps; ensure you also purchase or have the "large side" clamps to fully secure the boots to both the intake ends and the center section.

Tip 2: Precision Tightening. When installing these clamps, tighten them until they are snug and the boot cannot be rotated by hand. Avoid over-tightening with power tools, as excessive force can cut into the rubber boot material, leading to premature failure and difficult-to-diagnose vacuum leaks.

Tip 3: The "Lean" Test. If you suspect an intake leak after installation, spray a small amount of carburetor cleaner or starting fluid around the clamped boot area while the engine is idling. If the engine RPM changes, the clamp may need adjustment or the boot may have a hidden crack that requires replacement.