ALUMINUM WHEELS for Karmann Ghia Convertible 1971

Lightweight aluminum rear wheels are half the weight of steel wheels. The use of aluminum wheels require a special stud kit sold seperately. Minimum offset puts the wheels further away from the machine where standard offsets brings them closer.
Not D.O.T approved

Diameter: 15 Inches
Width: 10 inches
Backspacing: 2 inches
Bolt Pattern: 4 on 130mm
Wall Thickness: .190

15x5.5 5v (3.5+2) no valve hole
Not D.O.T. Approved

.190 Wall Thickness
Diameter: 15 Inches
Width: 5-1/2 inches
Backspacing: 1 inches
Bolt Pattern: 5 on 205mm

Lightweight aluminum rear wheels are half the weight of steel wheels. The use of aluminum wheels require a special stud kit sold separately. Minimum offset puts the wheels further away from the machine were standard offsets brings them closer. Not d.O.T. Approved
.190 Wall Thickness

Diameter: 15 Inches
Width: 10 inches
Backspacing: 2 inches
Bolt Pattern: 5 on 205mm

Lightweight aluminum rear wheels are half the weight of steel wheels. The use of aluminum wheels require a special stud kit sold separately. Minimum offset puts the wheels further away from the machine were standard offsets brings them closer.
.190 Wall Thickness
Not D.O.T. Approved

Diameter: 15 Inches
Width: 12 inches
Backspacing: 2 inches
Bolt Pattern: 5 on 205mm