Wiper Arm Right, Black, For Beetle 73-77, Super 71-72

OVERVIEW

Maintain crystal-clear visibility and restore the factory-fresh appearance of your classic Volkswagen with this premium EMPI Right Side Wiper Arm. Over decades of exposure to the elements, original wiper arms often suffer from weakened internal springs, chipped paint, and stripped splines, leading to poor blade contact and unsightly streaks across your windshield. This replacement arm is engineered to meet original equipment standards, providing the precise tension required to keep your wiper blade firmly pressed against the glass, even during heavy downpours or at highway speeds. Finished in a durable, sleek black coating, it serves as the perfect functional upgrade for any daily driver or show-quality restoration project.

Installation is a straightforward process that instantly improves the safety and aesthetic of your Beetle''s front end. Because this is a right-side (passenger side) specific component, it features the correct geometry and offset to clear the hood and cowl area perfectly on late-model Standard Beetles and early Super Beetles. Don''t let a tired, floppy wiper arm compromise your safety during a rainstorm; upgrading to this high-quality EMPI unit ensures that your wiper system operates with the reliability and efficiency that Volkswagen intended. Whether you are battling a light mist or a sudden deluge, this arm provides the structural integrity and clamping force necessary for a streak-free view of the road ahead.

FITMENT

This wiper arm is designed specifically for the following air-cooled Volkswagen models:

• VW Beetle (Standard): 1973, 1974, 1975, 1976, 1977
• VW Super Beetle: 1971, 1972 (Does NOT fit 1973 and later Super Beetles with curved windshields)
• Position: Right Side (Passenger Side)

SPECS

• Brand: EMPI
• Part Number: 111-955-408H
• Finish: Satin Black Coating
• Material: High-Strength Pressed Steel
• Mounting Style: Splined shaft fitment with securing nut provision
• Weight: 0.25 lbs
• GTIN: 636684708217

PRO TIPS

Tip 1: Clean Your Splines Before Installation

Before sliding your new EMPI wiper arm onto the wiper motor shaft, take a moment to inspect the splines on the shaft itself. Over time, debris, corrosion, and even small bits of metal from the old arm can clog these grooves. Use a small wire brush or a dental pick to clear out the channels. If you attempt to torque down a new arm over dirty splines, it may not seat deeply enough, which can lead to the arm stripping out the first time you use the wipers in heavy snow or rain. A clean mating surface ensures a "lock-tight" fit that will last for years.

Tip 2: Verify Your Windshield Type

The transition years for the Super Beetle can be confusing for many owners. This specific arm (111-955-408H) is designed for the flat windshield found on 1971-1972 Super Beetles and 1973-1977 Standard Beetles. If you own a 1973 or later Super Beetle, your car features a curved "panoramic" windshield, which requires a completely different wiper arm geometry. Always double-check if your glass is flat or curved before ordering to ensure you get the correct part for your specific dash and cowl configuration.

Tip 3: Test Without the Blade First

After you have secured the new arm to the shaft, but before you snap the wiper blade into place, carefully cycle the wiper motor once. Watch the travel of the arm to ensure it stops exactly where it should and doesn''t strike the windshield rubber seal or the metal cowl. Since these arms are held on by splines, it is easy to accidentally install them one or two "teeth" off-center. Adjusting the position now, before the blade is attached, prevents you from scratching your glass or damaging the motor by having the arm bind against the bodywork.